Sec.38a-88-15. The Actuarial Method

(a) Actuarial Method. The actuarial method to establish the required level of primary security for each reinsurance contract subject to sections 38a-88-13 to 38a-88-19, inclusive, of the Regulations of Connecticut State Agencies shall be VM-20, applied on a contract-by-contract basis including all relevant definitions from the valuation manual as then in effect, applied as follows:

(1) For covered policies described in section 38a-88-14(3)(A) of the Regulations of Connecticut State Agencies, the actuarial method is the greater of the deterministic reserve or the net premium reserve regardless of whether the criteria for exemption testing can be met. However, if the covered policies do not meet the requirements of the stochastic reserve exclusion test in the valuation manual, then the actuarial method is the greatest of the deterministic reserve, the stochastic reserve or the net premium reserve. In addition, if such covered policies are reinsured in a reinsurance contract that also contains covered policies described in section 38a-88-14(3)(B) of the Regulations of Connecticut State Agencies, the ceding insurer may elect to instead use subdivision (2) of this subsection as the actuarial method for the entire reinsurance agreement. Whether this subdivision or subdivision (2) of this subsection is used, the actuarial method must comply with any requirements or restrictions that the valuation manual imposes when aggregating these policy types for the purposes of principle-based reserve calculations.

(2) For covered policies described in section 38a-88-14(3)(B) of the Regulations of Connecticut State Agencies, the actuarial method is the greatest of the deterministic reserve, the stochastic reserve or the net premium reserve regardless of whether the criteria for exemption testing can be met.

(3) Except as provided in subdivision (4) of this subsection, the actuarial method is to be applied on a gross basis to all risks with respect to the covered policies as originally issued or assumed by the ceding insurer.

(4) If the reinsurance contract cedes less than one hundred percent (100%) of the risk with respect to the covered policies then the required level of primary security may be reduced as follows:

(A) If the reinsurance contract cedes only a quota share of some or all of the risks pertaining to the covered policies, the required level of primary security, as well as any adjustment under subparagraph (C) of this subdivision, may be reduced to a pro rata portion in accordance with the percentage of the risk ceded;

(B) If the reinsurance contract in a non-exempt arrangement cedes only the risks pertaining to a secondary guarantee, the required level of primary security may be reduced by an amount determined by applying the actuarial method on a gross basis to all risks, other than risks related to the secondary guarantee, pertaining to the covered policies, except that for covered policies for which the ceding insurer did not elect to apply the provisions of VM-20 to establish statutory reserves, the required level of primary security may be reduced by the statutory reserve retained by the ceding insurer on those covered policies, where the retained reserve of those covered policies should be reflective of any reduction pursuant to the cession of mortality risk on a yearly renewable term basis in any exempt arrangement;

(C) If a portion of the covered policy risk is ceded to another reinsurer on a yearly renewable term basis in an exempt arrangement, the required level of primary security may be reduced by the amount resulting by applying the actuarial method, including the reinsurance section of VM-20, to the portion of the covered policy risks ceded in the exempt arrangement, except that for covered policies issued prior to January 1, 2017, this adjustment is not to exceed [c_x/ (2* number of reinsurance premiums per year)] where cₓ is calculated using the same mortality table used in calculating the net premium reserve; and

(D) For any other contract ceding a portion of risk to a different reinsurer, including but not limited to stop loss, excess of loss and other non-proportional reinsurance treaties, there shall be no reduction in the required level of primary security.

(5) It is possible for any combination of subparagraphs (A), (B), (C) and (D) of subdivision (4) of this subsection to apply. Such adjustments to the required level of primary security shall be done in the sequence that accurately reflects the portion of the risk ceded via the contract. The ceding insurer shall document the rationale and steps taken to accomplish the adjustments to the required level of primary security due to the cession of less than one hundred percent (100%) of the risk. The adjustments for other reinsurance shall be made only with respect to reinsurance treaties entered into directly by the ceding insurer. The ceding insurer shall make no adjustments as a result of a retrocession contract entered into by the assuming insurers.

(6) In no event shall the required level of primary security resulting from application of the actuarial method be required to exceed the amount of statutory reserves ceded.

(7) If the ceding insurer cedes risks with respect to covered policies, including any riders, in more than one reinsurance contract subject to sections 38a-88-13 to 38a-88-19, inclusive, of the Regulations of Connecticut State Agencies, in no event shall the aggregate required level of primary security for those reinsurance treaties be less than the required level of primary security calculated using the actuarial method as if all risks ceded in those treaties were ceded in a single contract subject to sections 38a-88-13 to 38a-88-19, inclusive, of the Regulations of Connecticut State Agencies.

(8) If a reinsurance contract subject to sections 38a-88-13 to 38a-88-19, inclusive, of the Regulations of Connecticut State Agencies cedes risk on both covered policies and non-covered policies, credit for the ceded reserves shall be determined as follows:

(A) The actuarial method shall be used to determine the required level of primary security for the covered policies, and section 38a-88-16 of the Regulations of Connecticut State Agencies shall be used to determine the reinsurance credit for the covered policy reserves; and

(B) Credit for the non-covered policy reserves shall be granted only to the extent that security, in addition to the security held to satisfy the requirements of subparagraph (A) of this subdivision, is held by or on behalf of the ceding insurer in accordance with sections 38a-85 and 38a-86 of the Connecticut General Statutes. Any primary security used to meet the requirements of this subparagraph may not be used to satisfy the required level of primary security for the covered policies.

(b) Valuation Used for Purposes of Calculations. For the purposes of both calculating the required level of primary security pursuant to the actuarial method and determining the amount of primary security and other security, as applicable, held by or on behalf of the ceding insurer, the following shall apply:

(1) For assets, including any such assets held in trust, that would be admitted under the NAIC Accounting Practices and Procedures Manual if they were held by the ceding insurer, the valuations are to be determined according to statutory accounting procedures as if such assets were held in the ceding insurer’s general account and without taking into consideration the effect of any prescribed or permitted practices; and

(2) For all other assets, the valuations are to be those that were assigned to the assets for the purpose of determining the amount of reserve credit taken. In addition, the asset spread tables and asset default cost tables required by VM-20 shall include in the actuarial method if adopted by the NAIC's Life Actuarial (A) Task Force, no later than the December 31st on or immediately preceding the valuation date for which the required level of primary security is being calculated. The tables of asset spreads and asset default costs shall be incorporated into the actuarial method in the manner specified in VM-20.

(Effective November 6, 2019)